Shopping Cart
Quantity in Cart: 0 - $0.00

30-06 Springfield Headspace Reamer w/ Bushing & Drive Rod

$158.99

A finish reamer designed to remove the last few thousandths from a "short chambered" barrel to properly headspace the rifle. The reamer is inserted into the chamber, allowing the bolt to push on the back of the reamer. A drive rod is threaded into the reamer, inserted from the muzzle and turned from the muzzle end. Finish ream the chamber until the bolt lugs drop-in for perfect headspace.

  • Insert the reamer into the pre or short chamber. Make sure the bushing is on the end of the reamer then screw the drive rod into the pilot of the headspace cutter after carefully slipping the drive rod down the barrel. Rotate the cutter with forward pressure applied to the bolt. Once the bolt rolls over and locks, clean the chamber and check headspace.
  • Base-to-shoulder length is minimum spec. If the headspace reamer is used properly the headspace in the rifle will fall within .001 inches of minimum.
  • It is important to check headspace as soon as the bolt is fully locked. If you continue turning the cutter after the bolt locks the bolt return spring will continue to apply forward pressure on the cutter and cause it to cut until the bolt lugs bottom on the front of the bolt lug recess. This will result in excess headspace.

  • If we have product in stock we will ship immediately. If we do not have in stock, please allow 1 to 8 weeks for delivery time.

    Add to Cart:

    • Shipping Weight: 1lbs


    Your IP Address is: 54.227.41.242
    Copyright © 2014 Pacific Tool & Gauge, Inc. Powered by Zen Cart
    Back to top